Seat Cover Assembly
Reverse Steps of Seat Cover Removal.
Cleaning the Seat Cover and Harness Pads
When required, Seat Cover and harness pads
may be machine washed with cold water and mild
detergent, on the delicate cycle.
Allow to air dry.
DO NOT use bleach or other harsh chemicals
to clean your Child Restraint Cover or Harness.
DO NOT attempt to iron your Child Restraint
Cover.
Recline Child Restraint to rear facing Position 1.
1 - Tuck the seat cover into the retaining
channel along the edge of the seat and tuck
the corner flap in near the screw.
From the center of the seating area, push
the white plastic tab on the seat cover
down over the screw
2 - while pulling down on the fabric from the
outside.
Ensure both corner pockets are secured to the
outside of the Calf Support.
1 2
66 RAVA instructions 67RAVA instructions
To Next Page
Loading...
