11
temperature during programming and the run.
04- Program No Display
Display of the program number from 0 to 9.
05- Running indicator leds
The 4 leds light up consecutively during the run to indicate the spinning of the rotor.
06- START key
Starts the centrifugation run.
07-STOP key
Stops the run by starting the braking phase manually.
08- LID key
Opens the lid if the lid indicator lights up.
09- LID Indicator Led
This led is on if the opening of the lid is possible.
10- START Indicator Led
This led turns on as the start button is pushed and turns off as the “Lid Indicator”(9) turns on
after the rotor has stopped spinning.
11-LID OPEN Indicator Led
It turns on if the lid remains open or is not properly closed.
12- Imbalance Indicator Led
It is activated if imbalance occurs. Brake is applied immediately.
13- Acceleration Indicator Led
It turns on while the acceleration rate is being programmed and while the rotor is accelerating.
14- Braking Indicator Led
This indicator turns on while the breaking rate is being programmed and while the rotor is
breaking.
15-Value Increase/Decrease Keys
They increase or decrease values during programming stage and to select the program
number during stand-by position. By pushing value increase key it is possible to see the set
values during centrifugation.
16- Function key
It is pushed to see the RPM or RCF value on the speed display during the run, to pass among
the displays and to store the programmed values.
17- Cooling Indicator Led*
It indicates that the cooling system functions. During programming, it indicates that the
temperature value is being set on Acc/Br/Temp Display (3).
* It is not valid for NF 800 model.
To Next Page
Loading...
