ASSEMBLY GUIDE (Continued)
Vacuum Lid Assembly
1. Underneath Vacuum Lid, make sure the Vacuum Plug is in place and
screw Vacuum Cap up into Vacuum Lid clockwise until tight.
2. Line up red dot (located on top of Lid) with the handle.
3. Push down on the Lid until it sits firmly in place.
• Make sure to turn the Release Valve to the Lock position before using
vacuum function.
• Vacuum Lid will NOT open when in Lock position.
Vacuum Cap
Vacuum Plug
Use Vacuum Lid when vacuum blending only.
Vacuum Lid
Jar
Release Valve
To Next Page
