Vacuum Arm
Switch
Jar Assembly with the Vacuum Lid
1. Lift the Vacuum Arm up.
2. Place the Jar on Base by aligning it on top of the 4 Rubber Columns.
3. The Vacuum Cap needs to be screwed tightly into place prior to use.
4. Push the Vacuum Arm down and press on Lid until a connection is made and
a “click” is heard.
5. Make sure the Release Valve is in Lock position before vacuuming.
• Before removing Vacuum Lid, turn the Release Valve to open position.
ASSEMBLY GUIDE (Continued)
4 Rubber Columns
CAUTION
Make sure all parts are securely attached.
To Next Page
