Using the BMC
DGX Station A100 DU-10189-001 _v5.0.2|22
We strongly recommend that you change your password. If you do not change your password,
anyone can use the default passwords and log in to the BMC.
3.6. Logging in After Entering an
Incorrect Password
After you enter an incorrect login BMC password at leat 5 times, you will be locked out. Here is
some important information about how you can log in to the BMC again.
After entering incorrect passwords at least 5 times, you will be locked out for 10 minutes
before you can attempt to log in again. During this 10-minute period, if you enter an incorrect
password again, the lockout period is extended.
The lockout period is calculated in the following way:
10 minutes * (failure count - 5 tolerances)
For example, if you entered incorrect passwords 7 times, you must wait for 20 minutes (10 * (7
– 5) before you can log in again.
Important: The start of the current lockout period is calculated from the latest incorrect
password that you entered and not from the first lock time.
If you need to unlock users immediately, you must reset the BMC.
3.7. Common BMC Tasks
This section provides information about the most common tasks you can complete in the BMC.
3.7.1. Configuring the BMC Login Credentials
Here is some information about how to add or remove users from the BMC.
1. Log into the BMC.
2. In the left navigation pane, click Settings.
3. Click the User Management card.
To Next Page
Loading...
Need help?
General
