Disable Dynamic Host Conguration Protocol (DHCP)
DHCP is used for automatic retrieval of management IP addresses.
If a user connects through SSH, runs the wizard and turns o DHCP, the connection is
immediately terminated, as the management interface loses its IP address. In such a case,
the serial connection should be used.
Remote Connection with NVIDIA Onyx (MLNX-OS)
Once the network attributes are set, you can access the CLI via SSH or the WebUI via
HTTP/ HTTPs.
To access the CLI, perform the following steps:
Note
<localhost># ssh admin@<ip-address>
Mellanox Onyx (MLNX-OS) Switch Management
Password:
Mellanox Switch
Mellanox configuration wizard
Do you want to use the wizard for initial configuration? yes
Step 1: Hostname? [my-switch]
Step 2: Use DHCP on mgmt0 interface? [yes] no
<localhost>#
To Next Page
Loading...
