NXP Semiconductors S32K148 User Manual

CONTENTS:
 Get to know the S32K148 T-BOX Reference Design Board
(RDB)
 S32K148 T-BOX RDB out-of-the-box setup
 Creating a new S32DS project for the S32K1xx MCU
 S32DS debugging basics
 Create a P&E debug configuration
S32K148 Telematics Box
Reference Design Board
GET TO KNOW THE S32K148-T-BOX REFERENCE DESIGN BOARD (RBD)
P1:Mic input
SW4: User
bottom
SW2 & SW3:
Touch Pad
J25&J27:
4G module
connector
Audio Codec:
STGL5000
Potentiometer
SW5: User
bottom
TJA1101 MCU:
S32K148
SBC:
UJA113x
J16:
Audio
OUT
J15:
Line
OUT
J15:
Line
OUT
RGB LED SBC HVIO
SW1: Reset
bottom
J26: BLE
module
connector
J5: CAN0
interface
J28: GPS
module
connector
J31:23-pin
ECU connector
Route signals with:
• 3x CAN bus
• 2x LIN bus
• 1x Ethernet
• 2x Analog input
• 2x HS output
• 2x Input Capture
• 12 V Power Supply
Figure 1: S32K148-T-BOX Reference Design Board (RBD)

NXP Semiconductors S32K148 Specifications

General

Processor	ARM Cortex-M4F
Core Size	32-Bit
Core Speed	up to 112 MHz
Maximum CPU Frequency	112 MHz
Temperature Range	-40°C ~ 125°C
Peripherals	DMA, PWM, RTC
Program Memory Type	Flash
Communication Interfaces	CAN, I2C, SPI, UART
Operating Voltage	2.7V to 5.5V

Summary

S32K148 T-BOX RDB Introduction

S32K148-T-BOX RDB Features

Key features and capabilities of the S32K148 T-BOX RDB.

Main Chips and Modules Documentation

Datasheets and references for main chips and modules.

S32K148-T-BOX RDB Software Package

Details on the S32K148 T-BOX RDB software package and its contents.

Hardware Pinout and Connectors

Arduino UNO Header Pinout Mapping

Maps Arduino UNO header pins to specific ports and signals.

S32K148 Header/Pinout Mapping

Maps external modules and MCU pins to connectors on the board.

23-Pin ECU Connector Details

Signal routing, wiring harness, and pin descriptions for the 23-pin ECU connector.

Board Setup and Operation

Power Supply Jumper Settings

Configuration options for power supply jumpers on the board.

LIN and RTC Clock Jumper Settings

Configuration options for LIN and RTC clock jumpers.

Ethernet and QSPI Usage

Instructions for using Ethernet and QSPI, including resistor configuration.

S32K148 T-BOX RDB Out-of-the-Box Setup

Steps to power up the board and connect the debugger for initial setup.

Software Development and Debugging

Creating Projects in S32 Design Studio

Guide to creating new projects using S32 Design Studio.

S32DS Debugging Fundamentals

Fundamental concepts and steps for debugging in S32DS.

P&E Debug Configuration

Steps to create a specific debug configuration using P&E.