Oce 7050 - Operator recoverable errors

Solving problems 39
Operator recoverable errors
When the copier detects an error, the copier stops immediately. The paper path
indicator will lit and the length display shows an error code.
The following explains the general procedure in case of an operator
recoverable error
▼
General procedure for operator recoverable errors
1
Remove the original.
2
Open the manual copy material feed table.
3
Remove the copy material.
4
Check the paper path.
5
Close the manual copy material feed table.
The following table gives an overview of possible causes and specific actions.
Error messages
Message Possible causes Specific actions
E0
■
Copy material is removed during
the copy process.
■
Stop button has been pressed
during a copy process.
■
Original feed problem.
Contact the key operator.
E1 Paper feed table is open. Close paper feed table.
E2 Copy material is too short Contact the key operator.