Oce 7050 - Instructions for safe use

50 Océ 7050/7051 User Manual
Instructions for safe use
Océ copiers and materials have been developed and tested in accordance with
the strictest international safety standards. To ensure safe working with these
products it is important that you observe the following safety rules:
■
Do not remove any screws from fixed panels.
■
The copier is not user-serviceable except for the components and
maintenance materials mentioned in this manual.
■
Do not place any liquids on the copier.
■
Use maintenance materials or other materials for their original purpose only.
Keep maintenance materials away from children.
■
Do not mix cleaning fluids or other materials.
■
To avoid risks, all modifications to Océ equipment are strictly reserved for
Océ service personnel. It is recommended to use only those copy-control
products that comply with (inter)national standards regarding product safety
and radio-frequency interference. It is also recommended to use attachment
cables specified by Océ.
■
The copier has been fitted with an ozone filter. If you have a maintenance
contract, the Océ service engineer will check this filter regularly and replace
it if necessary.
Correct operation is guaranteed only if the filter is replaced by Océ.
■
Do not move the copier yourself. Contact your Océ Customer Service when
you wish to move the copier. If for some reason you have to move the copier
yourself, please make sure that the mains power point has the right fuse
capacity. See the Océ 7050/7051 safety data sheet in this appendix for
information about fuses.
■
Do not bridge any mechanical or electrical circuit breakers.
■
Do not use an extension lead to connect the copier.
■
Locate the copier close to a wall socket that is easily accessible.
■
The switch in the fixed connection (if any) should be easily accessible.
■
This copier has not been designed for connection to an IT power system. (An
IT power system is a voltage network in which the neutral wire is not
connected to earth).
■
Do not block the ventilation openings of the copier.
■
Ensure that the copier is placed on a level, horizontal surface of sufficient
strength. See the Océ 7050/7051 safety data sheet in this appendix for
information about the weight of the copier.
■
Ensure there is sufficient space around the copier. This facilitates reloading
materials as well as maintenance.