Scanner Agent will automatically detect a single scanner. On multiple attachment config-
urations, the first scanner will be detected automatically.
Rescan Hardware Bus(es)
Use this option to redetect the scanner or detect a new scanner attached to your USB
interface, after you boot your system.
Launch Scanner maintenance
Use this option to start the Scanner maintenance wizard which will guide you through
the camera alignment and calibration procedure.
Note:
These two options above are available if the Océ Scan and Scanner maintenance have
been previously installed on your computer.
Restore Océ Scanner Agent
Use this option to display the Océ Scanner Agent main interface.
About Océ Scanner Agent
This option displays information about the version of Océ Scanner Agent.
Exit
Use this option to exit the Océ Scanner Agent application. The scanner icon is removed
from your system tray.
Chapter 8 - Océ Scanner Agent74
Interface of Océ Scanner Agent
To Next Page
Loading...
