Replacing the glass plate
Introduction
Replacing the glass plate: Your documents move against the glass plate as they pass the
scanner's sensors. After long-term use, the glass plate can become worn or scratched and
this can affect image capture precision. Changing the glass will renew your scanner and
ensure optimal results.
The illustration below shows the scanner from above with its lid open. The illustration
indicates the key parts and buttons you need to recognize when replacing a worn glass
plate. The glass plate is held and locked in place with 4 small white-colored latches. Each
latch can be released from the glass plate by pressing down on its corresponding latch
release button. Each latch release button is placed in a square hole just under the latch it
releases.
Caution:
Disconnect the power plug. This step is to ensure your own personal safety and to help
protect your device from potential damage.
Attention:
The glass plate is long and thin and thus fragile. Take care not to break it.
Overview of the key parts
#
Overview
1 = Glass plate
2 = Four Glass plate latches (these hold the glass plate in place)
3 = 4 Glass plate latch release buttons in the square holes
Chapter 7 - Maintenance52
Replacing the glass plate
To Next Page
Loading...
Need help?
General
