Remote control receiver
To ensure optimum operation of the IR remote control, do not cover
this window.
Status indicators
Protection Red LED lights up when the electronic protection
system has switched the amplifier off in response to an
amplifier fault. (See Chapter 9)
Soft-start Lights up during the soft-start process immediately
after switch-on. This LED goes out after about 1
minute when soft-start has been completed. (See
Chap. 3.4. + Chap. 7.4. + Chap. 7.5.)
Extern Illuminates to indicate separate pre and power
amplifier operation. (see Chapter 7.2.)
Headphone Illuminates when headphones are connected.
(See Chapter 7.5.)
Front Ch. Illuminates when multichannel-bypass function is on.
(See Chapter 6.7.)
Ecomode Illuminates when Ecomode/power saver mode is on.
(See Chapter 7.4.)
Mode selector knob
Linear Pre and power amplifier are connected internally.
(Chapter 7.1.)
Extern Pre and power amplifier are separate.
(See Chapter 7.2.)
BIAS The electronic bias measurement system is on and the LED
array shows the power tubes' idle current.
(See Chapter 8.3.)
To Next Page
Loading...
Need help?
General
