3. ENGINE
3-
1. Plug
2. O-ring
4. Remove the crankshaft position sensor (CPS),
1. CPS
2. Screw
5. Set piston no. 2to TDC ignition by turning the
crankshaft.
1. Allen key74mm
5.1 The rear piston is at TDC when it's index mark
on the magneto flywheel is aligned with notch in
the magneto cover.
PISTON N0. 2 AT TDC
1. Mark “2” on magneto flywheel
2. Notch on magneto cover
3. Crankshaft position sensor location
5.2 Confirm printed marks on the camshaft timing
gear are parallel to cylinder head base, in the lower
position.
NOTE: If printed marks on camshaft timing gear
are not as specified, turn crankshaft 360°.
NOTE: In this position the piston is set to TDC
ignition.
To Next Page
Loading...
