ODES UTV Desertcross 1000cc-3 - Lower Suspension Arm; Upper Suspension Arm

8. BRAKES SYSTEM
8-
3
Lower Suspension Arm
Inspect the suspension arm and for damage
or distortion. If any damages or distortion
are found, replace the suspension arm with
a new one.
Move suspension arm from side to side.
There should be no noticeable loose.
Replace bushing if necessary.
Move suspension arm up and down.There
should be no noticeable loose. Replace
bushing if necessary.
Upper Suspension Arm
Inspect the suspension arm and for damage
or distortion. If any damages or distortion
are found, replace the suspension arm
with a new one.
Move suspension arm from side to side.
There should be no noticeable loose.
Replace bushing if necessary.
Move suspension arm up and down.There
should be no noticeable loose. Replace
bushing if necessary.
Check ball joint for damage, pitting,
looseness and roughness. If so ,replace it.
Checl ball joint bellows for cracks. Change if
necessary.
REASSEMBLY
Reassemble and remount the front
suspension in the reverse order of removal
and disassembly. Pay attention to the
following points.
1. Install the washers and tighten the
knuckle nuts to the specified torque.
2. Replace the removed cotter pins with
new cotter pins.