6.DRIVE TRAIN
6-
Check if the bearing in knuckle move
freely and smoothly. If not, replace them.
Installation
Apply grease to the splines and insert the end of drive shaft in differential and pull joint a little to
make sure that the stop ring is locked in differential side gear groove.
Insert the other end of drive shaft in the knuckle and install the knuckle to the lower suspension
arm. Install and torque the ball joint retaining bolts to 45N.m
Install all other removed parts.
FRONT DIFFERENTIAL
Remove
Clean the drain plug area.Place an
oil pan under the front reducer
case,and then drain oil completely by
removing the drain plug.
Raise front of vehicle, support it
securely on jack stands and remove
front wheels.
On both sides,
remove the drive shafts.
To Next Page
Loading...
