2.PERIODIC MAINTENANCE
2-
CAUTION
Replace gearbox oil
Prior to change the gearbox oil, ensure vehicle is
on a level surface, should be done with a warm
engine.
1. Drive vehicle for a few minutes.
2. Ensure vehicle is on a level surface.
3. Stop engine and wait a few minutes.
4. Lift the rear cargo bed.
5. Remove the oil level check plug.
6. Place an oil pan under the gearbox
case, and then drain oil completely by
removing the drain plug.
7. Tighten the drain plug to 20
N.m(14.76Lbf.ft).
8. Pour the specified oil(GL-4-90) about
360~450mL by syringe through the oil
level check hole.
9. Tighten the oil level check dipstick.
FRONT DIFFERENTIAL OIL
To change the front differential oil, locate the
vehicle on a level position and carry out the
following steps.
Clean the oil level check plug area and remove
the oil level check plug.
In order to expand service life of vehicle, please use grade SJ standard engine oil conforming
to API with its viscosity indication being SAE10W/40. If viscosity of engine does not reach SAE
10W/40, make corresponding selection according to drawing.