ODES UTV Desertcross 1000cc-3 - Page 25

2.PERIODIC MAINTENANCE
2-
17
Unscrew bleed screws on top of
thermostat housing.Both cylinders must be
bled.
Unscrew bleed bolt on top of raditor.
Fill up the radiator with coolant, when the
coolant comes out by the thermostat housing
hole, install the bleed screws with its gasket
ring and torque to 10 N.m(7.38Lbf.ft).
Start the engine and let idling.
Continue adding coolant to radiator, when the
coolant comes out by the radiator bleed hole,
install the bleed bolt with its gasket ring and
torque to 10 N.m(7.38Lbf.ft).
Press and relax the throttle pedal five times to
bleed air bubbles completely.
Refill coolant to radiator, and install the the
radiator pressure cap.
Run engine until radiator fans open(Must all the
fans work).
Stop the engine. When engine has completely
cooled down, recheck coolant level in the
coolant radiator, Top up if necessary.
CAUTION
Bleed
screw
Check the general condition of hoses and clamps for tighten.Check the leak indicator pipe in
front of water pump for oil and coolant.