ODES UTV Desertcross 1000cc-3 - Page 68

3. ENGINE
3-
38
Intake Manifold Installation
The installation is the reverse of the removal
procedure. However, pay attention to the
followin9.
Tighten intake manifold retaining screws to
specified torque one cylinder at a time.
INTAKE MANIFOLD RETAINING
SCREWS
Tightening torque
20N·m±2.5N·m
(15lbf·ft 士 2 lbf·ft)
Tighten elbow retaining screws to specification.
INTAKE MANIFOLD RETAINING
SCREWS
Tightening torque
10N·m±1N·m
(89lbf·ft 士 9 lbf·ft)
Tighten intake manifold clamps to specification.
INTAKE MANIFOLD RETAINING
SCREWS
Tightening torque
0.7N·m±0.1N·m
(6lbf·ft 士 1 lbf·ft)
Enable fue1 pump using B.U.D.S.