OHAUS DV114C - Button Control Functions

EN-9Ohaus Discovery
3.2 Button Functions
Four multifunction buttons and two tare buttons are used to to operate the balance and navigate the menus. The function of each button is
shown below.
Press and Release
Press and Hold
Menu Function
Primary Function Tare
• Performs tare
operation.
On/Zero
• If balance is off,
turns balance on.
• Zeros balance.
Print
• Sends the current
display value to the
serial interface.
Function
• Operation is depen-
dent on the applica-
tion mode.
Cal
• Initiates calibration
function.
Secondary Function Off
• Turns balance off.
Unit
• Change weighing
unit. Press and hold
will scroll through
units.
Mode
• Change application
mode.
Menu
• Press and hold
allows entering the
menu.
Menu Function Yes
• Accepts the current
(blinking) setting on
the display.
• When editing in the
alpha-numeric field,
increments to the
next digit.
No
• Rejects the current
setting (blinking) on
the display.
• Increments a value
being entered.
Back
• Reverts back to the
previous menu item.
• Decrements a value
being entered.
Exit
• Immediately exits
menu mode.
• Aborts calibration
in progress.
80104130.indd Sec1:9 2011/11/25 9:08:35