EN-16 SCOUT
TM
SJX SERIES BALANCES
5.3 Service Information
If the troubleshooting section does not resolve or describe your problem, contact your
authorized OHAUS service agent. For service assistance or technical support in the United
States call toll-free 1-800-672-7722 ext. 7852 between 8:00 AM and 5:00 PM EST. An OHAUS
product service specialist will be available to provide assistance. Outside the USA, please visit
our web site, www.ohaus.com to locate the OHAUS office nearest you.
5.4 Accessories
TABLE 5-2. ACCESSORIES
Note: * Bluetooth kit is only available in certain regions according to the local regulations.
6. LEGAL FOR TRADE
When the balance is used in trade or a legally controlled application it must be set up, verified
and sealed in accordance with local weights and measures regulations. It is the responsibility of
the purchaser to ensure that all pertinent legal requirements are met.
6.1 Settings
Before verification and sealing, perform the following steps in Order:
1. Verify that the menu settings meet the local weights and measures regulations.
2. Units menu should be reviewed. Verify the units turned On meet the local weights and
measures regulations.
3. Perform a calibration as explained in Section 4.2.
3. Set the position of the Security Switch to the locked position.
6.2 Sealing
After the Balance has been verified, it must be sealed to prevent undetected access to the
legally controlled settings. Before sealing the device, ensure that the security switch is in the
Locked position.
If using a wire seal, pass the sealing wire through the holes in the security switch and Bottom
Housing as shown.
If using a paper seal, place the seal over the security switch and Bottom Housing as shown.
To Next Page
Loading...
