Paper handling > 21
2. Position the continuous forms supply directly below the printer, no
more than 3 cm left or right of the printer paper path.
3. Ensure the rear of the printer is close to and parallel with the edge
of the surface and at least 60 cm from any wall.
Feeding continuous forms
1. Ensure that the printer is turned ON.
NOTE
If there is a cut sheet in the printer, eject it as described in "Ejecting
cut sheet paper" on page 20.
2. Ensure the Paper Type Lever (1) is set to Continuous Forms .
3. Adjust the Paper Thickness Lever to suit the paper. See "Setting
the Paper Thickness lever" on page 26.
NOTE
If the Paper Thickness Lever setting does not match the paper being
used, paper feeding and printing may not work properly.
To Next Page
Loading...
