Operating instructions > 30
Button switches
SWITCH STATUS FUNCTION
SEL On-line Sets the printer to off-line
Off-line Sets the printer to on-line and
disalarms the printer
SHIFT Used only in conjunction with
one of the following buttons:
SEL, LF, FF/LOAD, PARK,
TEAR described below.
LF On-line Feeds paper by one line.
Holding the button down results
in continuous line feeding.
Off-line Feeds paper by one line.
Holding the button down results
in continuous line feeding.
FF/LOAD On-line and off-line
Continuous Forms mode
Continuous form fed until first
line of next page
On-line and off-line
Cut sheet manual mode
Ejects the cut sheet
TEAR On-line
Continuous Forms mode
Delivers the continuous form
to the cut position. If the button
is pressed again or data is
received, the original form
position is restored.
On-line
Cut sheet manual mode
Ineffective
Off-line Ineffective
PARK Continuous Forms mode If the continuous form is in
position, press to retract the
form to the Pin Tractors.
(If the sprocket holes of the last
page of the form disengage
from the sprocket pins, do not
attempt to eject the paper as a
paper jam may result.)
SHIFT+SEL Enters menu mode
To Next Page
Loading...
