B930n User’s Guide> 70
Important
• The EtherTalk port setting in this printer is disabled by
default. To use this port, enable the setting on the
Operator Panel.
CONFIGURATION
The B930 is a fast 100BASE-TX/10BASE-T network capable printer.
It supports major protocols such as TCP/IP and Ethertalk. This
section details configuring the printer's network interface and should
be done prior to configuring your computer.
IP ADDRESS
The factory configuration is for the printer to obtain an IP address
automatically from your networks’ DHCP server. Use the printers’
Operator Panel to determine the printers’ address.
If the DHCP server is not available or not in use, use one of the
following methods to retrieve and set the IP address.
• Set the IP address manually from the Operator panel or EWS
Important:
• Depending on the network environment, you may need to set
the subnet mask and gateway address.
• Please check with your network administrator if you have any
questions concerning your network environment.
PRINTER SETUP USING THE EWS
If the printer is connected to the network using TCP/IP, its settings
can be configured using the EWS.
To apply configuration changes using a Web browser, select the
Administrator Login. You will be prompted for a username and
password. The username is [root] and the default password is the
last six digits of the Ethernet MAC address. The MAC address can be
found on the Network Summary page. Note that the password is
case sensitive and letters should be entered in upper case.
The following explanation uses Windows XP and Internet Explorer
version 6.0 as an example to manually set the printers IP address.
To Next Page
Loading...
Need help?
Performance
Memory
Weight and Dimensions
