NetBEUI > 87
N
ET
BEUI
T
HE
NETWORK
INTERFACE
CARD
IS
NOT
IDENTIFIED
> Turn the printer off for 15 seconds and then on again.
> Make sure the network cable is correctly connected.
> Change the cable and try again.
> Make sure that Microsoft network client and NetBEUI
have been added to the network section of the control
panel.
> Make sure the NetBEUI protocol is set to Enable.
> Make sure the factory setting of the workgroup name is
PrintServer and the computer name is ML+ the last six
digits of the MAC address.
> Make sure the computer name of the NIC is different from
the computer name on the network.
E
RROR
WRITING
TO
PRN
1
> Make sure the printer is online.
> If there is an error message indicating the paper has run
out, add more paper and cancel the error.
> Check whether another user is printing. Print after the
other user has finished.
To Next Page
Loading...
