Paper recommendations > 13
M
ULTI
PURPOSE
TRAY
The multi purpose tray can handle the same sizes as the cassette trays but in weights up
to 220
g/m². For very heavy paper stock use rear output tray (face up). This ensures that
the paper path through the printer is almost straight.
The multi purpose tray can feed paper widths from 64mm to 216mm and lengths from
127.0mm to 1320mm (banner printing).
For paper lengths exceeding 356mm (Legal 14in.) use paper stock between 90g/m² and
128g/m² and rear output tray (face up).
Use the multi purpose tray for printing on envelopes. Up to 10 envelopes can be loaded at
one time, subject to a maximum stacking depth of 10mm.
O
UTPUT
TRAY
(
FACE
DOWN
)
Output tray on the top of the printer can hold up to 150 sheets of 80g/m² standard paper,
and can handle paper stocks up to 176g/m².
Pages printed in reading order (page 1 first) will be sorted in reading order (last page on
top, facing down).
The number of sheets that can be stacked on the face down stacker may vary depending
on environment.
R
EAR
OUTPUT
TRAY
(
FACE
UP
)
Rear output tray at the rear of the printer should be opened and the tray extension pulled
out when required for use. In this condition paper will exit via this path, regardless of driver
settings.
Rear output tray can hold up to 100 sheets of 80g/m² standard paper, and can handle
stocks up to 220
g/m².
Always use this stacker and the multi purpose feeder for paper stocks heavier than
176g/m².
D
UPLEX
Automatic two-sided printing on the same range of paper sizes as tray 2 (i.e. all cassette
sizes except A6), using paper stocks from 64 - 176g/m².
To Next Page
Loading...
Need help?
General
