Operator panel > 41
PCL S
ETUP
ITEM SETTINGS EXPLANATION
FONT SOURCE RESIDENT
RESIDENT2
Specifies the location of the PCL default font.
Normally this will be INTERNAL unless additional
fonts are installed in the expansion ROM slot or
additional fonts have been downloaded to RAM as
permanent fonts.
FONT NO. I0
C1
S1
Sets the current default font number from the
currently selected source.
FONT PITCH 0.44 CPI
~
10.00 CPI
~
99.99 CPI
Sets the width of the PCL default font in
characters/inch (CPI).
Default font is the fixed-pitch, scalable font. The
value is displayed to the second decimal place.
Displayed only when the font selected in Font No.
is fixed-spacing, scalable font.
FONT HEIGHT 4.00 POINT
~
12.00 POINT
~
999.75 POINT
Height of the PCL default font.
Note: This menu item is displayed only when the
font selected in Font No. is a proportional-
spacing, scalable font.
SYMBOL SET PC-8
(Default Symbol
Set
only shown)
Selects a PCL symbol set.
A4 PRINT WIDTH 78 COLUMN
80 COLUMN
Sets the number of columns subject to Auto LF
with A4 paper in PCL. This is the value when Auto
CR/LF Mode is set to OFF with the 10CPI
character.
WHITE PAGE SKIP ON
OFF
Selects whether blank pages are printed or not.
CR FUNCTION CR
CR+LF
Selects whether a received carriage return
character (0Dh) also causes a line feed.
LF FUNCTION LF
LF+CR
Selects whether a received line feed character
(0Ah) also causes a carriage return.
PRINT MARGIN NORMAL
1/5 INCH
1/6 INCH
Sets the non-printable page area. NORMAL is PCL
compatible.
TRUE BLACK ON
OFF
PCL: Sets if to use Composite Black (CMYK
mixed) or Pure Black (K only) for the black
(100%) in image data.
PEN WIDTH ADJUST ON
OFF
When minimum width is specified in PCL,
sometimes a 1-dot line, looks broken.
With PEN WIDTH Adjust set to ON, when the
minimum width is specified, the line width will be
emphasized so as to look wider than a 1-dot line.
With PEN WIDTH Adjust set to OFF, the line will
appear as before.
To Next Page
Loading...
Need help?
General
