Operator panel > 40
PS S
ETUP
COLOR
DENSITY
CYAN DENSITY -3~0~+3 Adjusts the density of each color
(cyan,magenta, yellow and black).
Normal setting is 0.
MAGENTA DENSITY -3~0~+3
YELLOW DENSITY -3~0~+3
BLACK DENSITY -3~0~+3
ADJUST REGSTRATION EXECUTE Performs automatic color registration
adjustment.
Normally this is done on power on and when
output tray is opened and then closed.
This process accurately aligns the cyan, magenta
and yellow images to the black image.
INK SIMULATION OFF
SWOP
EUROSCALE
JAPAN
Selects from a range of industry standard color
swatches.
Note: This function only applies to PS models
UCR LOW
MEDIUM
HIGH
Selects limitation of the toner layer thickness.
If paper curl occurs in dark printing, selecting
MEDIUM or LIGHT sometimes helps reduce curl.
CMY100% DENSITY ENABLE
DISABLE
When enabled, black areas are produced using
100% C, M, and Y instead of black.
This results in a glossier finish.
CMYK CONVERSION ON
OFF
Setting to “OFF” will simplify the conversion
process of CMYK data, which will reduce the
processing time.
This setting is ignored when Ink Simulation
function is used.
Note: This function only applies to PS models
ITEM SETTINGS EXPLANATION
L1 TRAY TYPE1
TYPE2
[TYPE1]: The tray selection number for the level
1 operator begins with 1.
[TYPE2]: The number begins with 0.
NET PS-PROTOCOL ASCII
RAW
Specifies a communication protocol mode for PS
data from a network.
USB PS-PROTOCOL ASCII
RAW
Specifies a communication protocol mode for PS
data from USB.
PDF PAPER SIZE CURRENT
TRAY SIZE
SIZE IN PDF
FILE
SCALING SIZE
Select the paper size of PDF Direct Print.
PDF SCALING SIZE 1%
~
99%
Specifies scaling size by percent when PDF Paper
Size is set to Scaling Size.
ITEM SETTINGS EXPLANATION
To Next Page
Loading...
Need help?
General
