- 52 -
2. Setting Up
13
Select a wireless LAN access point to connect, and then press [Select].
If only [Manual Setup] is displayed, or the SSID of the wireless LAN access point you want to use is not included
in the list, set by following the procedure in "
Setting from the Operator Panel Manually to Connect".
The encryption key entry screen that is suitable for the encryption method of the selected wireless LAN access
point is displayed.
14
Enter the encryption key that you checked in step 1, and then press [OK].
The encryption key varies depending on the wireless LAN access point or security.
•
If the [WPA Pre-shared Key] is displayed
•
If [WEP Key] is displayed
•
If neither of the above two cases is applied
15
If the displayed SSID is the same as the SSID that you checked in step 1,
press [Yes].
When "Connection successful." is displayed, press [Close].
If "Connection failed." is displayed, repeat the procedure from step 5.
Item Description
Security WPA/WPA2-PSK
Encryption key Enter the Pre-shared Key.
Item Description
Security WEP
Encryption key Enter the WEP key.
Item Description
Security Disable
Encryption key No entry is required.
To Next Page
Loading...
Need help?
General
