C6100 Series User’s Guide
140
NOTE
Warning! If the printer has been printing, the
fuser will be HOT!
If the sheet is well advanced into the fuser (only
a short length is still visible), do not attempt to
pull it back. See step 4 under “Jam 382” .
To remove a sheet trapped in the fuser:
1. Grasp the edge of the sheet.
2. Push the fuser pressure release lever (1)
towards the front and down.
3. Lift out the sheet.
4. Let go of the fuser pressure release lever.
c53_64_jambelt2.jpg
To Next Page
Loading...
