C6100 Series User’s Guide
167
Check to see if saved Driver Settings are
used____________________________
You can make changes to the driver settings and save them
(under a named driver) for later use. You can do this if you are
using PCL and/or Mac drivers.
Before making changes to driver settings, always check to see
if a Named Driver is being used.
To do this:
1. Open the file you want to print.
2. Click File → Print.
3. Select your printer.
4. Click Properties.
5. Click the Setup tab (if necessary).
6. Look at the list below Driver Settings. If you see any
name other than Default, a Named Driver is being used.
7. If a Named Driver is being used, you can
select “Default” in the list below Driver. This restored
all driver settings to the factory defaults. You can then
proceed with your changes.
proceed with your changes and not save them. Use the
changes for only a single print job.
proceed with your changes and save them as the same
Named Driver.
proceed with your changes and save them under a new
Named Driver.
To Next Page
Loading...
Need help?
General
