- 37 -
Connecting to a Computer
1
1. Setup
14 Remove “Software DVD-ROM” from the
computer.
Finish by test printing from a computer.
1 Start up [TextEdit].
2 Open an appropriate le.
3 Start printing.
The installation is complete.
If installing the options such as an
additional tray unit, specify the settings
with a printer driver. Refer to “When
Adding Options” P.52
Using TCP/IP
(For Mac OS X 10.3.9 to 10.4.11)
When connecting to the network with TCP/IP,
it is necessary to disable the sleep mode in the
printer. After doing that, install the driver on
the computer and set the printer as a network
printer.
Memo
● The following procedure uses Mac OS X 10.4.11 as an
example. Depending on an OS, the description may be
different.
1 Press the <ENTER> button on the
operator panel.
2 Press the scroll button several times
to select [Admin Setup], and press the
<ENTER> button.
䎩䏘䏑䏆䏗䏌䏒䏑䏖䎃䎃䎃䎃䎃䎃䎕䎒䎕
䫹
䎦䏄䏏䏌䏅䏕䏄䏗䏌䏒䏑
䎤䏇䏐䏌䏑䎃䎶䏈䏗䏘䏓
3 Enter the administrator password, using
the numeric (0-9) keys.
The factory default password is “aaaaaa”. Press
<ENTER> button after each character you input.
䎨䏑䏗䏈䏕䎃䎳䏄䏖䏖䏚䏒䏕䏇
䯴䎙䎐䎔䎕䏇䏌䏊䏌䏗䏖䎌
4 Press the <ENTER> button.
To Next Page
Loading...
