- 36 -
Connecting to a Computer
1
1. Setup
Installing a Printer Driver
(For Mac OS X)
To complete the network connection with a Mac
operating system, install a printer driver on the
computer and set your printer as a network
printer.
Select the protocol for your network connection
from the following:
● TCP/IP
● Bonjour (Rendezvous for Mac OS X 10.3)
Note
● EtherTalk is not supported.
● Disable the anti-virus software before starting this
procedure.
Using TCP/IP (For Mac OS X 10.5
to 10.7)
First, install the printer driver on the
computer.
1 Insert the “Software DVD-ROM” into the
computer.
2 Double-click the [OKI] icon on the
desktop.
3 Double-click [Driver] > [Printer] >
[Installer for Mac OSX].
4 Enter the administrator’s password for
Mac OS X, and then click [OK].
Follow the instructions displayed on the screen to
complete the installation.
5 From the Apple menu, select [System
Preferences].
6 Click [Print & Scan] ([Print & Fax] for
Mac OS X 10.5 and 10.6).
7 Click [+].
8 For Mac OS X 10.7, click [Add Other
Printer or Scanner].
9 Click [IP].
10 Enter IP address in [Address].
Check that [OKI C822(PCL)] is
displayed in [Print Using]
11 Click [Add].
12 Check that your printer is displayed in
[Printers] and [OKI C822(PCL)] is
displayed in [Kind].
Note
● If [OKI C822(PCL)] is not correctly displayed
in [Kind], click [-] to remove your printer from
[Print & Scan] ([Print & Fax] for Mac OS X 10.5
and 10.6) and then redo the procedure from steps 7
to 11.
13 Close [Print & Scan] ([Print & Fax] for
Mac OS X 10.5 and 10.6).
To Next Page
Loading...
