Oki C910 - Page 270

Oki Data CONFIDENTIAL
44043511TH Rev.2
269 /
Function
LCD
Status Message Help Message
Shows that, because of paper jamming that was
caused in the printer, paper that was fed after
jammed paper remains in the printer.
Error 643 : Finisher POS1: Input Area
Error 645 : Finisher POS3: Paper Stack Eject
Check Finisher
Paper Remain
Please see HELP for details
Error Code: nnn
[Context]
Paper is stuck around the finisher
due to a paper jam.
[Action]
Remove any paper seen near
the exit part of the finisher.
Detach the finisher from the
inverter, by pressing the lever
on the finisher.
Remove any paper seen near
the entrance of the finisher.
Open the top cover of the
finisher, and remove any
remaining paper.
Close the top cover.
Connect the inverter to the finisher.
Shows that, because of paper jamming that was
caused in the printer, paper that was fed after
jammed paper remains in the printer.
Error 644 : Finisher POS2: Saddle Transport
Path
Error 646 : Finisher POS4: Saddle Stack Eject
Check Finisher
Paper Remain
Please see HELP for details
Error Code: nnn
[Context]
Paper is stuck inside the finisher
due to a paper jam.
[Action]
Separate the finisher from the
inverter by pressing the finisher
lever.
Open the front cover of the
finisher.
Output any remaining paper
by turning the lower knob
clockwise.
Remove the outputted paper.
Close the front cover.
Open the right side cover of the
finisher.
Remove any remaining paper.
Close the right side cover.
Connect the finisher to the inverter.
Shows that, because of paper jamming that was
caused in the printer, paper that was fed after
jammed paper remains in the printer.
Error 647 : Inverter POS1: Paper Eject
Error 648 : Inverter POS2: Reverse Stacker
Area
Error 649 : Inverter POS3: Input Area
Check Inverter
Paper Remain
Please see HELP for details
Error Code: nnn
[Context]
Paper is stuck near the inverter
due to a paper jam.
[Action]
Separate the finisher from the
inverter by pressing the finisher
lever.
Open the left side cover of the
inverter to remove any remaining
paper.
Close the left side cover.
Connect the finisher to the inverter.
Separate the inverter from the
printer, pressing the inverter lever.
Open the right side cover of
the finisher and remove any
remaining paper.
Close the right side cover.
Connect the finisher to the inverter.