Printer and paper overview > 18
T
RAY
AND
STACKER
EXAMPLES
L
OADING
TRAYS
1
TO
5
Tray 1 is used in the following example.
1. Pull out the tray.
2. Press the paper rear stopper tab (1) and adjust the tab to the required paper size.
3. Fan the paper to be loaded then tap the edges of the stack on a flat surface to make
it flush.
4. Load the paper (face down and top edge towards the right for headed paper), press
the tab (2) on the paper guide and adjust the guides (3) for a snug fit to the paper.
To avoid paper jams:
> Do not leave space between the paper and the guides and rear stopper.
> Do not overfill the paper tray. Capacity depends on the paper type.
> Do not load damaged paper.
1
To Next Page
Loading...
Need help?
General
