Getting started > 30
I
NTERFACES
AND
CONNECTION
Your printer is equipped with a selection of data interfaces:
> Parallel – For direct connection to a PC. This port requires a bi-directional (IEEE
1284 compliant) parallel cable.
> USB – This port requires a cable conforming to USB version 2.0 or above.
> The printer may not work if a USB- compatible device is connected concurrently with
other USB-compatible machines.
> When connecting multiple printers of the same type, they appear as *****, *****
(2), ***** (3), etc. These numbers depend on the order of connecting or turning on
each printer.
> Ethernet – For network cable connection.
C
ONNECTING
THE
PARALLEL
INTERFACE
1. Turn off the printer and the computer.
2. Connect the parallel cable between the printer and computer.
3. Turn on the printer and then the computer.
C
ONNECTING
THE
USB
INTERFACE
Do not connect the USB cable at this time. You will be instructed when to connect the USB
cable when you run the Drivers DVD.
If you are connecting your printer directly to a stand alone computer proceed to the section
entitled “Using the drivers DVD” on page 31.
NOTE
Interface cables are not supplied with your printer.
To Next Page
Loading...
Need help?
General
