Menu functions > 24
USB
MENU
This menu controls the operation of the printer’s USB data interface.
ITEM DEFAULT REMARKS
USB ENABLE Enables or disables the USB data interface.
SOFT RESET DISABLE Enables or disables the SOFT RESET command.
SPEED 480Mbps Selects the interface speed.
OFFLINE RECEIVE DISABLE Enables or disables this function. When set to
Enable, the interface retains a receive possible state
even when switching to Offline. Interface sends the
BUSY signal only when the receive buffer is full or a
service call occurs.
SERIAL NUMBER ENABLE Specifies whether to ENABLE or DISABLE a USB
serial number.
The USB serial number is used to identify the USB
device connected to your PC.
NOTE
When you have changed any settings in the USB MENU, turn the printer OFF,
then ON again.
To Next Page
Loading...
