Menu functions > 25
N
ETWORK
MENU
This menu controls the operation of the printer’s 10Base-T/100Base-TX network interface.
ITEM DEFAULT REMARKS
TCP/IP ENABLE Enables or disables this network protocol.
IP VERSION IP v4 Sets up the IP version.
Operates with IP v4 only (not valid with IPv6).
Operates with both IP v4 and IPv6.
Operates with IPv6 only (not valid with IPv4).
From this stage, if IPv6 only is set from UI, for
example Telnet, “IP v6” appears as the value of IP
Version on the operation panel. “IP v6” will disappear
from the value if “IP v4” or “IP v4+v6” is selected.
Display Condition: TCP/IP should be enabled.
NETBEUI DISABLE Enables or disables this network protocol.
NETBIOS OVER TCP ENABLE Sets Enable/Disable of NetBIOS over TCP protocol.
Display Conditions:
> TCP/IP should be enabled.
> IP Version is not IPv6.
NETWARE DISABLE Enables or disables this network protocol.
ETHERTALK DISABLE Enables or disables this network protocol.
FRAMETYPE AUTO Selects the Ethernet MAC layer frame type.
Display Condition: Netware should be enabled.
IP ADDRESS SET AUTO Specifies whether IP address allocation is automatic
(DHCP) or manually assigned.
IP ADDRESS xxx.xxx.xxx.xxx Current assigned IP address. To change, press ENTER
and use Menu buttons to increment 1st octet, then
press ENTER again to move on to next octet. When 4th
octet has been set, press ENTER again to register new
address.
SUBNET MASK xxx.xxx.xxx.xxx Current assigned subnet mask. To change, proceed as
above.
GATEWAY ADDRESS xxx.xxx.xxx.xxx Current assigned gateway address. To change,
proceed as above.
WEB ENABLE Enables or disables Web config. facility.
TELNET DISABLE Enables or disables Telnet config. facility.
FTP DISABLE Enables or disables communication via FTP.
IPSEC DISABLE Sets Enable/Disable of IPSec. Enable via the web.
Enable: IPSec is available.
Disable: IPSec is not available.
SNMP ENABLE Enables or disables SNMP protocol.
NETWORK SCALE NORMAL Selects network size.When NORMAL is selected,
printer can work effectively, even when connected to a
HUB that has a spanning tree feature. However, printer
start up time gets longer when computers are
connected with two or three small LANs.When SMALL
is selected, computers can cover from two or three
small LANs to a large LAN, but may not work
effectively when connected to a HUB that has a
spanning tree feature.
To Next Page
Loading...
