Maintenance > 59
2. Holding it by its top centre, pull the used EP toner cartridge out slowly.
3. Put the assembly down gently onto a piece of paper to prevent toner from marking
your furniture and to avoid damaging the green drum surface.
4. Take the new EP toner cartridge out of its packaging and place it on the piece of
paper where the old cartridge was placed. Leave its wrapping material in place for
the moment.
5. Pack the old cartridge inside the packaging material for disposal.
6. Remove the wrapping material.
7. Holding the complete assembly by its top centre, lower it into place in the printer
locating the pegs (1 & 2) at each end into their slots in the sides of the printer cavity
(3).
CAUTION!
The green image drum surface at the base of the EP toner cartridge
is very delicate and light sensitive. Do not touch it and do not
expose it to normal room light for more than 5 minutes. If the drum
unit needs to be out of the printer for longer than this, please wrap
the cartridge inside a black plastic bag to keep it away from light.
Never expose the drum to direct sunlight or very bright room
lighting.
3
2
1
To Next Page
Loading...
