Troubleshooting > 67
7. Remove any jammed paper from the fuser.
(a) To remove a sheet just entering the fuser (1), grip the trailing edge of the sheet,
lift the fuser pressure release levers (2) up and press toward the rear to release
the fuser’s grip on the sheet, and withdraw the sheet through the cavity area.
(b) To remove a sheet in the fuser; pull the retaining lever (3) towards the front of
the printer to release the fuser. Withdraw the fuser unit using the handle (4).
(c) Lift the fuser pressure release levers (2) up and press toward the rear to release
the fuser’s grip on the sheet. Pull the trapped paper from the fuser.
(d) Replace fuser unit into the machine and move locking lever (3) toward the rear
of the machine.
NOTE
If the sheet is well advanced into the fuser (only a short length is still visible),
do not attempt to pull it back.
2
3
4
2
To Next Page
Loading...
