Why does my Oki lan 8100e say 'INSTALL PAPER CASSETTE 430: TRAY 1 MISSING'?
If your Oki Printer displays 'INSTALL PAPER CASSETTE 430: TRAY 1 MISSING', it means Tray 1 is not installed. Install the missing tray to resolve the issue.
How do I fix the 'CLOSE COVER 316: DUPLEX COVER OPEN' error on my Oki lan 8100e Printer?
To resolve the 'CLOSE COVER 316: DUPLEX COVER OPEN' error on your Oki Printer, ensure that the duplex cover is fully closed and properly latched.
What does 'YYYY nnn: FATAL ERROR' mean on my Oki lan 8100e Printer?
If you see 'YYYY nnn: FATAL ERROR' on your Oki Printer, try turning it off and then back on. If the problem persists, write down the message, including the error number “nnn,” and any scrolling octets, then contact your authorized Oki Data Service Dealer.
How to enable interface on Oki lan 8100e Printer?
If the interface is disabled on your Oki Printer, check that the USB interface is set to Enable in the menu (USB MENU ? USB ? ENABLE).
Should I use a converter, buffer, extension cable or USB hub with Oki Printer?
If a converter, buffer, extension cable, or USB hub is being used with your Oki Printer, test by connecting the printer and computer directly.
How to correctly configure printer driver for Oki lan 8100e?
If the printer driver is incorrectly configured for your Oki Printer, correctly configure the printer driver.
How to replace toner on Oki lan 8100e when it's empty?
To resolve a 'REPLACE TONER nnn: * TONER EMPTY' error on your Oki Printer, replace the indicated toner. The codes are: 410: Y = Yellow, 411 M = Magenta, 412: C = Cyan, 413: K = Black.
What to do if Oki lan 8100e does not go online?
If your Oki Printer does not go online, switch it off and disconnect the power cable. Reconnect the power cable and switch the printer back on. If this does not clear the fault, call for service.
Why does my Oki lan 8100e frequently jam?
To address frequent paper jams in your Oki Printer, ensure the printer is on a stable, level surface and that you're using the correct type of paper. Store paper within specified temperature and humidity levels. Remove any creased or wrinkled paper, and adjust the tray or manual feed guides. Also, verify the correct paper feed selection in the printer driver's Properties Setup tab.
What to do if Oki lan 8100e doesn't print after clearing jam?
If your Oki Printer continues not to print after clearing a jam, raise and gently lower the top cover, especially if the paper jam was removed from behind the front cover.
To Next Page
General
