13
Service Maintenance Menu Structure is shown below.
Level 1 Level 2 Level 3 Level 4 Reboot
Process
OKIUSER
When Closed
Format HDD
When Executed
Format Flash ROM
When Executed
Menu Reset
None
All Reset
When Executed
Test Print Menu
When Closed
System
Maintenance
(See Section 2.3)
Change Password
New Password When Closed
Verify Password When Closed
LED Test
None
LCD Test
None
Panel
Maintenance
(See Section 2.4)
OP Key Test
None
Copy Maintenance
Color Copy
When Closed
Retrieve Shading Data
None
Clean RADF Roller
None
Side Reg. None FBS
Front Edge None
Side Reg. None
Front Edge None
ADF (Front)
Back Edge None
Side Reg. None
Front Edge None
Scan
Maintenance
(See Section 2.5)
Adjust Scan Position
ADF (Back)
Back Edge None
Country Code
When Closed
Echo support None
TX
Modem transmission speed None
Echo support None
RX
Modem transmission speed None
Pulse Make Ratio
None
ON period None
MF(Tone) Duration
Off Period None
Calling Timer
None
Attenuator
None
MF Attenuator
None
Relay
None
Tonal
None
Fax Maintenance
(See Section 2.6)
Line Test
DTFM
None
IBM 5577
When Closed
IBM PPR III XL
When Closed
EPSON FX
When Closed
Personality
HP-GL/2
When Closed
Peak Control
When Closed
Printer
Maintenance
(See Section 2.7)
Engine Diag. Mode
When Closed
Supplementary Description of “Reboot Process”
When Closed
Reboot starts automatically when the [Close] button is pressed on the top screen of the service menu.
Reboot when executed Reboot starts automatically when the function is executed.
None Reboot is not executed and the screen moves into the normal operating condition when the [Close] button
is pressed on the top screen of the service menu.
To Next Page
Loading...
