Oki MC-860 / CX2633MFP - Factory;Shipping Mode Switching

Printed Sheets Counter Display
This self-diagnostic menu is used to display the number of printed sheets status of the MFP.
1. Enter the self-diagnostic mode and press the (2) key or (8) key until
[PRINTER STATUS] is displayed on the screen.
Press the (6) key to execute.
The (2) key increments the test item and (8) key decrements the test item.
2. When the (2) key or (8) key is pressed, number status of the printed sheets are
displayed in order. Pressing the (*) key or the (#) key is invalid.
When the (4) key is pressed, the screen exits the test. (Screen returns to the item 1
condition.)
Display Unit of Measure Details
K – IMPRESSIONS Images
Y – IMPRESSIONS Images
M – IMPRESSIONS Images
C – IMPRESSIONS Images
Number of printed sheets for each
color are displayed.
TOTAL SHEET CNT
Prints Total number of printed sheets
are displayed.
2.7.7 Factory/Shipping Mode Switching
This self-diagnostic menu is used to switch the PU PCB from the Factor mode to the
Shipping mode.
1. Enter the self-diagnostic mode (Level 1) and press the (2) key or (8) key until the
following message is displayed.
2. When the (6) key is pressed, the following message is displayed.
Press the (2) key or (8) key until the desired item (refer to the table below) is displayed.
3. While desired item to set is being displayed, press the (6) key to enable operator to
select the setting value.
4. While desired item to set is being displayed, press the (6) key for an extended time (3
seconds) to register the display value in EEPROM. Screen returns to the item 2
condition.
When the (4) key is pressed, the screen exits the test. (Screen returns to the item 1
condition.)
43