166 Replacing Consumables
Replacing the Fuser Unit
For optimum print quality and performance, use only approved Oki fuser unit for
your specific machine type.
1 Turn off the machine and discon-
nect the power cord.
Note
There are extremely hot parts within the machine. Before replacing the fuser
unit, wait about 20 minutes after turning off the machine, and then check that
the fusing section has reached room temperature, otherwise, you may get
burnt.
2 Open the scanner unit.
" If there is paper in the output
tray, remove it, and then fold
up the output tray before
opening the scanner unit.
To Next Page
Loading...
Need help?
General
