- 32 -
Unpacking and Installing the Machine
1
2
4
5
6
3
(3) Flex the stack of paper back and
forth a few times. Then, make a
neat stack by straightening its
edges against a level surface.
Note
•
Using paper that is not recommended may
cause the machine to malfunction.
& For details about paper, see "Supported Paper"
(P.56).
(4) Load the paper with the side to
be printed on face down.
Set the direction
of the paper.
The side to be printed
on should be face down.
Mark
Note
•
Load the paper, making sure that it does not
exceed the mark on the paper guide. (300
pieces at 80g/m2)
(5) Set the paper size dial to match
the size of the paper.
Rotate the paper size dial until
it shows the size of paper
contained in the cassette.
Paper Size Dial
(6) Close the tray cassette.