GETTING STARTED > 15
F
ITTING
THE
P
APER
S
EPARATOR
The Paper Separator is utilised when using single sheets (no carbons)
and when using continuous stationery to separate the ingoing/
outgoing paper to prevent paper jams. It is fitted as follows:
1. Grasp the paper separator by either side, with the spring
loaded stays to the rear of the printer.
2. Locate the two hooked lugs on the edges of the paper
separator into the two corresponding slots in the top of the
printer.
3. Release paper separator on to the top of the printer.
To Next Page
Loading...
