2 User’s Guide
4. Open the top front cover by pressing down at each end and then lift
up the cover.
5. Remove the screw securing the retainer plate to the print head and
then remove this retainer plate.
6. Remove the two shipping retainers (red rubber) from each end of
the platen.
7. Close the top front cover and press down at each end to lock the top
cover in place.
Note:
Save the retainer plate, shipping retainers and
packaging in case you ever need to ship the printer.
Installing Ribbon Cartridge
1. Make sure the printer is off line and the print head has moved to the
gap in the platen.
Note:
If there is no paper installed in the printer, turn the
printer off and manually move the print head to the
gap in the platen before installing the ribbon
cartridge.
2. Switch the printer off and disconnect the power supply.
3. Open the top front cover by pressing down at each end and then lift
up the cover.
4. Unpack the ribbon cartridge and open the two guide arms (1) on the
cartridge.
5. Remove the ribbon retainer (2) and push in the roller arm claw (3).
To Next Page
Loading...
