- 108 -
Specifications
Continuous paper (with black marks)
W2
D
C
L4
L6
BL
BW
BW
BW
BL
BL
BL
L1
L1
L4
L4
L4
L5
L5
L5
L6
L6
L6
L5'
L2
A
L2
A A A
L2
B B B
Paper feed direction
Printing range
Black mark
Winding direction
Outside winding: Printable surface faces out.
Inside winding: Printable surface faces in
Paper weight 0.07 to 0.25 mm (0.003 to 0.0098 inches)
Core Inner diameter: 76.2 mm (3 inches)
Outer diameter 203.2 mm (8 inches) or less
Other W2
:
Paper width 25.4 to 130 mm (1 to 5.12 inches)
L1
:
Black mark interval
15.9 to 1324.0 mm (0.626 to 52.126 inches)
* The black marks contain carbon.
L2
:
Paper length 12.7 to 1320.8 mm (0.5 to 52 inches)
L4
:
Cut size when in cut mode 101.6 mm (4 inches) or more
However, if the length of one label is less than 101.6 mm
(4 inches), then the shortest length is 101.6 mm
(4 inches) as multiple sheets are cut
L5
:
Upper edge cutting margin 1.7 mm (0.067 inches)
L5'
:
Position of leading edge of
paper
1.2 to 4.0 mm (0.0472 to 0.1575 inches)
Length of leading margin when paper is loaded
L6
:
Lower edge cutting margin 1.5 mm (0.059 inches)
BW
:
Black mark width More than 5 mm (0.197 inches) from edge of paper (*1);
maximum is width of paper W2 from edge of paper
BL
:
Black mark length 3 mm (0.12 inches)
A
:
Top margin 2.12 mm (0.0835 inches)
B
:
Bottom margin 3.2 mm (0.126 inches) * In practice, it is the length of
the gap
C
:
Left margin 2.12 mm (0.0835 inches) or more
D
:
Right margin 2.12 mm (0.0835 inches) or more
(*1) If an accurate position to start printing on the leading edge is needed, use a black mark in the center of the paper's width.
To Next Page
Loading...
