- 109 -
Specifications
Die-cut label paper
W1
W2
W4
W3
L1
L2
L1
L3
L3
L2
D
C
A
B
A
B
L4
L6
L6
L5
L5
L6
L5
L6
L2
A
B
B
L3
L4
L4
L4
A
L5'
Paper feed direction
4R1 or greater
Printing range
Liner
Winding direction
Outside winding: Printable surface faces out.
Inside winding: Printable surface faces in
Paper weight 0.07 to 0.25 mm (0.003 to 0.0098 inches)
Core Inner diameter: 76.2 mm (3 inches)
Outer diameter 203.2 mm (8 inches) or less
Other W1
:
Liner width 29.4 to 130 mm (1.1575 to 5.12 inches)
W2
:
Label width 25.4 to 126 mm (1 to 4.9606 inches)
W3
:
Right liner width 2 to 25.4 mm (0.0787 to 1 inch)
W4
:
Left liner width 2 to 25.4 mm (0.0787 to 1 inch)
L1
:
Label pitch 15.7 to 1330.8 mm (0.618 to 52.3937 inches)
L2
:
Label length 12.7 to 1320.8 mm (0.5 to 52 inches)
L3
:
Gap between labels 3 to 10 mm (0.12 to 0.3937 inches)
L4
:
Cut size when in cut mode
101.6 mm (4 inches) or more
However, if the length of one label is less than 101.6 mm
(4 inches), then the shortest length is 101.6 mm
(4 inches) as multiple sheets are cut
L5
:
Upper edge cutting margin 1.7 mm (0.067 inches)
L5'
:
Position of leading edge of
paper
1.2 to 6.5 mm (0.0472 to 0.2559 inches)
Length of leading liner when paper is loaded
L6
:
Lower edge cutting margin 1.3 to 8.3 mm (0.051 to 0.3268 inches)
A
:
Top margin 2.12 mm (0.0835 inches) or more
B
:
Bottom margin 2.12 mm (0.0835 inches) or more
C
:
Left margin 2.12 mm (0.0835 inches) or more
D
:
Right margin 2.12 mm (0.0835 inches) or more
To Next Page
Loading...
