Oki Pro1040 - Page 27

- 27 -
If Other Messages Are Displayed
Message displayed on the
display screen
Error
code
ATTENTION
lamp
Causes and Troubleshooting
Reference
pages
The job was cancelled due to a
paper width mismatch
To turn off the display, press OK
button
Please see HELP for details
7386 Blinking Printing was stopped and the data
was deleted because the paper width
settings were different from those
specified in the printer driver.
Press the <OK> button to delete the
display on the display screen.
Press the <HELP> button, and solve
according to the guidance shown on the
Help screen.
-
Press OK Button for Restoration
Memory Overflow
420 Blinking Cannot print. Printing data has
exceeded the memory capacity of the
printer.
Select a lower Quality of the printer
driver and print once again.
Press the <OK> button to delete the
display on the display screen.
User’s Guide
> 3. Print
Function
Settings >
Fine Quality
Printing
Resume Print from
Page xxx/xxx
Press OK Button
Please see HELP for details
502 Blinking Printing can be resumed.
Press the <OK> button to print the rest
of the pages.
To cancel printing, press the <CANCEL>
button.
-
Non Genuine Print Cartridge
[COLOR]
Please see HELP for details
6840
6841
6842
6843
6844
Blinking Print cartridge is not intended for use
with this printer model.
Use a print cartridge intended for use in
this model.
-
Incompatible Print Cartridge
[COLOR]
Please see HELP for details
6900
6901
6902
6903
6904
7000
7001
7002
7003
7004
7040
7041
7042
7043
7044
7100
7101
7102
7103
7104
7200
7201
7202
7203
7204
Blinking Print cartridge is not intended for use
with this printer model.
Use a print cartridge intended for use in
this model.
-
Non Genuine Fuser and Exit Unit
Please see HELP for details
6981 Blinking Fuser and exit unit is not intended for
use with this printer model.
Use a fuser and exit unit intended for
use in this model.
-
Incompatible Fuser and Exit Unit
Please see HELP for details
6982
6983
6984
6985
6986
6987
Blinking Fuser and exit unit is not intended for
use with this printer model.
Use a fuser and exit unit intended for
use in this model.
-