Oki Pro1040 - Page 28

- 28 -
If Other Messages Are Displayed
Message displayed on the
display screen
Error
code
ATTENTION
lamp
Causes and Troubleshooting
Reference
pages
Non Genuine Belt Unit
Please see HELP for details
6881 Blinking Belt unit is not intended for use with
this printer model.
Use a belt unit intended for use in this
printer model.
-
Incompatible Belt Unit
Please see HELP for details
6882
6883
6884
6885
6886
Blinking Belt unit is not intended for use with
this printer model.
Use a belt unit intended for use in this
printer model.
-
Receiving Data Timeout
Press OK Button for Restoration
Please see HELP for details
519 Blinking A data receipt timeout occurred.
Increase the length of timeout print
setting.
-
Check Data
Message Data Write
Error<[CODE]>
- - Failed to write the message data to be
updated.
Check data.
-
Fuser and Exit Unit Not Installed
Please see HELP for details
699 Blinking The fuser and exit unit is not installed
properly.
Press the <HELP> button, and solve
according to the guidance shown on the
Help screen.
-
Check Fuser and Exit Unit
Please see HELP for details
348
320
Blinking The fuser and exit unit is not installed
correctly.
Install the fuser and exit unit correctly.
-
Install Fuser and Exit Unit
Please see HELP for details
333 Blinking The fuser and exit unit is disconnected.
Press the <HELP> button, and solve
according to the guidance shown on the
Help screen.
-
Caution, unknown Consumable
detected
Go to User Manual Trouble
Shooting to restore operation
709 Blinking This error means that a non-OKI
Original consumable has been installed
in the machine.
The warranty is applicable when the
product is used with its designated OKI
Original consumables. Use caution
when choosing other consumables.
The entire risk as to the quality and
performance of the product due to the
use of non-OKI Original consumables
is with you. Should the product prove
defective due to non-OKI Original
consumables, you assume the cost
of all necessary servicing, repair or
correction, as our warranty may not
cover these defects.
To accept these risks and to restore
function:
1. Turn off your product.
2. Press and hold the <CANCEL>
button and turn your product on.
3. After start up, release the <CANCEL>
button.
Note: this operation will be recorded for
future reference.
-
A spot color printing error has
occurred. Data will be erased.
Check the paper and paper
settings, and try to print again.
To turn off the display, press OK
button.
Please see HELP for details
459 Blinking Because of a print request for paper
unavailable to spot color printing, the
printing has been stopped, and the data
was deleted.
Check the paper and paper settings,
and print again.
Press the <OK> button to delete the
display on the display screen.
-